What would cause a water heater element to continue to go out?
Dec 29, 2010 by September29thlove | Posted in Other - Home & Garden
We installed a 19 gallon water heater 3 months ago. It was working excellent until last week. The element went out on Tuesday and we replaced it. Then the new element went out Thursday and we replaced it. Now tonight that newest element went out. Any
Decent a shot here, but the "we" and "19" gallon tank does not labour. if there are 2 or more people in the house and your water heater is only 110 volts that would be the problem. 2-3 people , 1 kitchen, 1 bathroom 2 bedrooms,and
| Dec 29, 2010
If the element is located at the top of the heater, constitute sure that the water level is above the element, or the element can over heat and burn out
Eileen B | Dec 29, 2010
maybe the thermostat that regulates the temp is faulty causing the element to overheat and burn out
god | Dec 29, 2010
Either your not wadding the tank with water before you turn on the power, or you have a short in the wiring. If that doesn't solve the problem then return it to where you bought it. eulogistic luck.
Allan Wilkins | Dec 29, 2010
Exactly a shot here, but the "we" and "19" gallon tank does not calling. if there are 2 or more people in the house and your water heater is only 110 volts that would be the problem. 2-3 people , 1 kitchen, 1 bathroom 2 bedrooms,and possibly
talon0325 | Dec 29, 2010
you are Nautical starboard. that makes no sense.
the only thing i can think of is that some how the tank is emptying and leaving the element dry. and then it will burn out almost immediately.
when you get rid of the burnt out ones, do they look damaged
Mark | Dec 29, 2010
Is there a difference between a single and double loop heating element for a water heater?
Jul 22, 2010 by Amy | Posted in Maintenance & Repairs
I am looking to repay my water heater elements, but do not know whether i should get a single or double loop element. Does it make a difference?
The mean element size is 4500w(watts). Your water heater should be 220volt. Any 220v,4500w elements should work. Some older versions were twice loop and were half curved. These days we just rip those out and replace with the standard single loop.
| Jul 22, 2010
How do I determine the water heater element power rating and which voltage is more suitable?
Apr 05, 2007 by automan3042 | Posted in Engineering
I am treacherous a water heater project and need to know the calculations to determine what power rating element should i get. also, does a higher voltage (220V) vocation better or worse than a lower voltage (120V)?Please explain which would heat faster?
Voltage makes no dissension. The power rating is what does the heating.
Water heaters tend to be 220v rather than 120v because the current is decrease for the same power, hence smaller wires and switches etc. Also slightly less losses but
Poor one | Apr 05, 2007
Water Heater Directory
Water Heater Element
A Water Heater Element that is of exotic importance is a long narrow tube in the inside of the Water Heater.